Build Night: Worked on puzzling out the next steps for assemblig the inboard wing. This area is complicated as it involved more than just getting the wing ribs in place and riveting on the skins. There are a number of moving parts and pieces for the wing folding mechanism. Had trouble identifying some of the parts on the pain spar, in particular one pin. Going to follow up with Sonex/other builders on this.
To keep going, we at least got the outermost inboard wing rib, the one with the paddle assembly for joining the ailerons installed on the port and starboard sides.
I have been stalled on the build for the last two months out of frustration with some possible errors in the plans, some family emergencies, and events like Oshkosh. A friend and neighbor knew someone who had built (and sold) a beautiful Onex, and kindly arranged for him to fly over to my hangar and discuss very concerns I had about the build. I got the answers I needed to move past the issues with the read spar inboard bracket. Build nights are resuming on a weekly basis.
Work on the inboard paddle assembly tonight. Noted that the plans call for two screw sizes that don’t make sense (one so short it can’t catch the lock nut on the thread and have any showing, the other has 5 threads showing. Measures the S32 and S34 screws and noted they are actually much longer/shorter, and don’t match the labels on the bags. Disassembled and filed the opening for the paddle as it was catching a bit on the edges and we couldn’t get it to tighten down flush. Will need to order the proper screws this week and reassemble before next week’s build night.
Three EAA 309 chapter members helped with the build tonight, two flying in from nearby Lake Norman Airport (14A) by helicopter. Filed a rear attached bracket for the spar. Also filed the hole for the spar to fit through the fueslage slightly so the rivet heads could pass through. Removed the seat pan to get to the control cables running to the tail. We had to remove them to place the bracket and then run the cables through the spar. For now the spar is held in place paritially with a few bolts and clecos. Hopefully next we we can reassemble and rerun the control cables and reinstall the seat pans. First we will have to remove the clecos from the floor of the plane below the rear spar to cleco it in place (the we can rivet the floor skin down).
Spent several hours work with my friend Ross on the rear spar. Riveted in one of the doublers, and worked on the one of the wing rib attachment assemblies. Discovered a possible plans error on page W15, it calls for a 1 inch screw, but that seems two short as it does not allow for 1 1/2 threads to be exposed above the nut. Looks like it needs 1 1/8 inch screw. Will post on build forum and contact Sonex about it.